Page 1 of 1

New rear bumper

PostPosted: June 13th, 2011, 1:35 pm
by casaintsfan
My new smack2020 fab rear bumper
Only sticks out 2" farther the bottom of the tub (1 1/2" farther than the rear door)[img]http://tapatalk.com/mu/ae86cfc5-8306-7f2d.jpg[/img]

Re: New rear bumper

PostPosted: June 13th, 2011, 2:02 pm
by VICTORG93307
Sweet looking.

sent from HTC evo iPhone killer.

Re: New rear bumper

PostPosted: June 13th, 2011, 2:50 pm
by Desert Dog
That is awesome!!!!

Did you guys cut the crossmember off? And if so, did you reinforce the inside of the bumper? (this type of bumper without reinforcement buckles in, PSC had to change their design because of this)

If its reinforced I WANT ONE!

(But, I would like the attachment points to be up higher , Id end up knocking those off in that spot)

Very nice :Thumb:

Re: New rear bumper

PostPosted: June 13th, 2011, 3:29 pm
by casaintsfan
[quote="desert dog"]That is awesome!!!!

Did you guys cut the crossmember off? And if so, did you reinforce the inside of the bumper? (this type of bumper without reinforcement buckles in, PSC had to change their design because of this)

If its reinforced I WANT ONE!

(But, I would like the attachment points to be up higher , Id end up knocking those off in that spot)

Very nice :Thumb:[/quote]


we did do a little reinforcing of the bumper plus it's 1/4" plate vs 3/16" that poison spyder uses

Re: New rear bumper

PostPosted: June 13th, 2011, 4:29 pm
by Desert Dog
[quote="casaintsfan"][quote="desert dog"]we did do a little reinforcing of the bumper plus it's 1/4" plate vs 3/16" that poison spyder uses[/quote][/quote]
So how do I order one ?

Re: New rear bumper

PostPosted: June 13th, 2011, 4:36 pm
by abendx
Bad ASS!! Damn.... where was Scott when I wanted a new bumper?

Re: New rear bumper

PostPosted: June 13th, 2011, 4:56 pm
by smack2020
That is Larry's design, I just helped him fab it up. Larry even did some of the cutting and welding. We reinforced the center, so I think it will be ok.

New rear bumper

PostPosted: June 13th, 2011, 7:28 pm
by Bert338
Looks good guys, you guys have the talent.