PI drivelines.

[REDxj5150]

So i'm gonna need a new front shaft, and many of you have brought up some shotty work by these guys. While others have liked their work. I guess I'd have to lead these guys by the hand to get something out of .188 or .250.

Should I just go with a reputable 4wd driveshaft company like JE Reel or tom woods? or just go with the local guys?

[Lake_v2]

I still suggest the local guys, but tell them exactly what you need.

.188 wall would be more than sufficient when you go to .25 wall its redundant and more costly to make

Do some searching on drivelines probably only find a few that run .25 wall

[REDxj5150]

Not actually going to run .250, just put that figure up there as an example. Apparently a Tom Woods shaft would only be 300. It's awfully tempting and they use much more beef with their axles.