Calamity at Ridgecrest on Sat

If you went on a run this is where to brag about it!

Calamity at Ridgecrest on Sat

Postby Goatman » November 29th, 2010, 8:49 am

A few of us went to Ridgecrest on Sat for the day. We stayed in the same spot on the trail from 10:30 to 5:30, had to weld/repair two rigs and had two rollovers in the same 30 feet of trail. But we still had a good time. :Thumb:

It started with Robert breaking a high steer arm off, it was the maiden run for his buggy that he bought used and then we did a bunch of work to, but didn't work on the steering or knuckles. We had to go back to camp to get stuff to weld with, and got it all put back together. We had to weld with three batteries, and my buggy wouldn't start afterwards. Fred and I had climbed up the side of the canyon a little to get out of the way while we did the repair, so Cliff climbed up the side of the canyon next to me so I could get a jump. While he was backing back down he rolled, and then a few minutes later Fred rolled all the way onto his roof while turning around on the side hill getting back down. I needed to winch Cliff over, so I had to turn around on the side of the canyon, without rolling, to get pointing down and got him back on his wheels. Cliff's motor was hydro locked, so the plugs had to be pulled.

Fred had a big rock that rolled down with him, so we couldn't winch him back up, he had to roll the rest of the way over downhill, and Cliff was the only one in position to winch him. So, after Cliff got going he pulled up and winched Fred back on his wheels. Then we saw a lot of oil coming out of Fred's rear housing. The butt weld where his outer housing bearing end and flange was welded to the housing tube had cracked badly when he rolled, so he drove up on a rock to keep the oil from running out. We pulled batteries back out and got him welded up. When we got all put back together and ready to go it was 5:30 and starting to get dark. We spent 7 hours in the same spot of trail.

Still better to be out with your friends on the trail than staying home. :clap:
Richard Gauthier
G[size=85]&[/size]G Off Road
G[size=85]&[/size]G Auto Repair
661-679-7957

'98 XJ
'89 XJ

[img]http://www.urfracing.com/forum/avatars/Jeeps/GoatMan.gif[/img]
Goatman
I work to support my 4X4!
 
Posts: 809
Joined: January 23rd, 2010, 6:23 pm
Location: Bakersfield

Re: Calamity at Ridgecrest on Sat

Postby munepit » November 29th, 2010, 8:54 am

Damm, Sounds like you need a Ready Welder!!!! Good times!!!
Jeff Carpenter
munepit
My 4X4 owns me!
 
Posts: 1118
Joined: August 3rd, 2010, 9:57 am
Location: Bakersfield

Calamity at Ridgecrest on Sat

Postby casaintsfan » November 29th, 2010, 11:46 am

[quote="Goatman"]A few of us went to Ridgecrest on Sat for the day. We stayed in the same spot on the trail from 10:30 to 5:30, had to weld/repair two rigs and had two rollovers in the same 30 feet of trail. But we still had a good time. :Thumb:

It started with Robert breaking a high steer arm off, it was the maiden run for his buggy that he bought used and then we did a bunch of work to, but didn't work on the steering or knuckles. We had to go back to camp to get stuff to weld with, and got it all put back together. We had to weld with three batteries, and my buggy wouldn't start afterwards. Fred and I had climbed up the side of the canyon a little to get out of the way while we did the repair, so Cliff climbed up the side of the canyon next to me so I could get a jump. While he was backing back down he rolled, and then a few minutes later Fred rolled all the way onto his roof while turning around on the side hill getting back down. I needed to winch Cliff over, so I had to turn around on the side of the canyon, without rolling, to get pointing down and got him back on his wheels. Cliff's motor was hydro locked, so the plugs had to be pulled.

Fred had a big rock that rolled down with him, so we couldn't winch him back up, he had to roll the rest of the way over downhill, and Cliff was the only one in position to winch him. So, after Cliff got going he pulled up and winched Fred back on his wheels. Then we saw a lot of oil coming out of Fred's rear housing. The butt weld where his outer housing bearing end and flange was welded to the housing tube had cracked badly when he rolled, so he drove up on a rock to keep the oil from running out. We pulled batteries back out and got him welded up. When we got all put back together and ready to go it was 5:30 and starting to get dark. We spent 7 hours in the same spot of trail.

Still better to be out with your friends on the trail than staying home. :clap:[/quote]

No pics = never happened



Lol


Sent from my iPhone using Tapatalk
[img]http://www.freeimagehosting.net/newuploads/7vesm.gif[/img]

[color=#000000][b]my webshots[/b]-------->[/color] [url]http://community.webshots.com/user/califsaintsfan?vhost=community[/url]

[color=#000000][b]my youtube[/b]------------>[/color] [url]http://www.youtube.com/user/casaintsfan[/url]
casaintsfan
Man I'm on here a lot!
 
Posts: 1327
Joined: January 21st, 2009, 12:40 pm
Location: 08

Re: Calamity at Ridgecrest on Sat

Postby Desert Dog » November 29th, 2010, 1:32 pm

Damn Richard, thats a lot of serious carnage. Glad nobody was hurt.
I AM THE TITTY MASTER
User avatar
Desert Dog
Offroad Prophet
 
Posts: 3268
Joined: November 29th, 2009, 7:42 pm
Location: da dale

Re: Calamity at Ridgecrest on Sat

Postby Mickey » November 29th, 2010, 3:53 pm

Nice run report...! Am kind of glad u guys don't invite me... lol you guys break too much... lol[color=#00BF40] :lol: [/color]
Mickey
I work to support my 4X4!
 
Posts: 832
Joined: January 26th, 2007, 3:45 am

Re: Calamity at Ridgecrest on Sat

Postby Goatman » November 29th, 2010, 6:17 pm

[quote="munepit"]Damm, Sounds like you need a Ready Welder!!!! Good times!!![/quote]

Ha Ha! Fred has a Ready Welder, but since we were going just for the day he left it at home. Really, it wouldn't have made that much difference, we still would've needed to pull the batteries for the Ready Welder. He's going to always bring it from now on.
Richard Gauthier
G[size=85]&[/size]G Off Road
G[size=85]&[/size]G Auto Repair
661-679-7957

'98 XJ
'89 XJ

[img]http://www.urfracing.com/forum/avatars/Jeeps/GoatMan.gif[/img]
Goatman
I work to support my 4X4!
 
Posts: 809
Joined: January 23rd, 2010, 6:23 pm
Location: Bakersfield


Return to Run Reports

Who is online

Users browsing this forum: No registered users and 0 guests

cron